Aquapoxy AQ Grout
- CLASSIC “ACID RESISTANT GROUT”
- FOR TILE JOINTS 0.5MM TO 3MM
- WATER BASED
- USER FRIENDLY
- CLASSIC “ACID RESISTANT GROUT”
- FOR TILE JOINTS 0.5MM TO 3MM
- WATER BASED
- USER FRIENDLY
AS4992 RATING ARG
12kg
Aquapoxy AQ is a three component acid resistant grout for ceramic tiles. Aquapoxy AQ cures to a general “chemically resistant” grout. Aquapoxy AQ is water based, easy to apply & clean and subsequently very user friendly.
Suitable Substrates
- Concrete/Cement Render
- Brickwork/Blockwork (Cement Rendered)
- Fibre Cement Sheets (Primed)
- Plasterboard (Primed)
Interior/Exterior
- Walls
- Floors
Suitable Tiles
- Bicottura
- Monocottura
- Fully Vitrified
Colour
- See Below for Colour selection
Precautions
unsuitable for:
- expansion joints or joints subject to movement
- unglazed natural tiles
- grouting moisture sensitive green marble
- tile joints with a width greater than 15mm
SPECIAL CARE REQUIRED
- Avoid grouting wet tile joints as Aquapoxy AQ will be diluted by water and cure to an inferior finish. Rough or slip resistant tiles are difficult to grout. Aquapoxy AQ will set on rough surfaces with an unsightly finish which will become very difficult to remove.
- Epoxy Wash, washed over installations after grouting, is recommended for rough or slip resistant tiles to help in cleaning tile surfaces close to the joints. Do not mechanically clean tiles as this will very likely damage the tile surface.
- Use the proportions supplied. For smaller applications, proportions must be weighed out on a scale at a rate of 150g Part 1: 150g Part 2: 900g Part 3.
Morgan Aquapoxy AQ Grout Colour Board
Sample board colours are representative of the available grout product, however each colour may vary on-site according to installation techniques and site conditions. Consequently Morgan makes no warranty or guarantee of any kind regarding the colour, texture, or appearance of a finished grout installation.
Related Products
Footer
